Pulse secure client mtu7/6/2023 ![]() Is there anything I can do from our side or from their client to resolve this issue, since the ISPs are very little help. I have not tried setting it lower than 1300.Īnother similarity between the users is that they use a small ISP (usually a neighborhood T1 or other non-cable/dsl). I also checked their MTU to set it at 1300 (I read somewhere that this can resolve connectivity issues). This issue seems to happen to only a few different users, so I suspected that it was an issue with their client and reinstalled. I am also unable to ping their address from inside the network. When I log into the VPN manager and check the sessions, I see that their session is showing 0 "Bytes Tx". Installing the Cisco VPN client on all PCs seems to resolve the problem. ![]() Im setting up a VPN with the SDM, link goes up ok, but traffic seems oddly sluggish. Have various customers with 857, 877, 1841, 2811 routers, same problem every time. The below command can be run to gather live logs for an Anyconnect client connection. ![]() They are able to connect the VPN client, but but they are unable to access any network resources. Get this same problem with any Cisco router site-site VPN. For the An圜onnect process on a Linux client On a Linux device, Anyconnect logs can be found in the file named 'syslog' at path:/var/log/ Here is a sample of working logs taken from a Linux client. I have been experiencing an intermittent problem with several of my users. My company has a VPN 3000 concentrator and our remote users use the Cisco VPN client to connect to our network. I have been searching for a few days for an answer to this issue, but didn't find anything close.
0 Comments
Leave a Reply. |